Smarthub update

zigbee-ad 1.0.0

Adapter changes

General improvements:

Update firmware to 0.5.10
Remove battery service from certain Aqara water leak sensors as they do not use it
More robust firmware update procedure
Update device information in network table after fimp discovery command
Resend Doorman config on adapter startup in case of an inclusion failure
Update device address when NewDevice and UpdateDevice events are received

Fixes:

Set the device as active for all device events not just heartbeats. This fixes the case where the app shows a signal failure for a working device.
Use a more robust method for saving files. This fixes occasionally not being able to control Doorman.

Firmware Changes

Use new SiLabs SDK. This brings significant improvements to network stability.
Fix Develco Smartplug dropping out after sometime.
Fix not being able to include more than 9 Aqara sensors.
Fix for the Read Attribute Response that shows empty values for the Basic Cluster
Improve handling the remove command: remove device from device list if we don't have its address and it is not responsive.
Fix a pointer issue that cause the NCP to reboot after removing a device from the network.
Fix firmware rebooting during Doorman inclusion.